NOTE: When the WIDTH control is turned fully counterclockwise the click can

become "blurred". In that case the use of the TONE control can solve the problem.

BALANCE(fig. 1-10)

Adjusts the volume difference between click 1 and click 2.

CLICK II WIDTH control (fig. 1-11)
See Click I Width.

TONE (fig. 1-12)

Adjusts the Softness of Click I and Click II. When the knob is turned clockwise the
clicks will get softer.

NOTE: The more the TONE knob is turned clockwise the less audible difference

between CLICK 1 and CLICK 2 will get.

LINE OUT Level control (fig. 1-13)
Controls Click I and Click II line out level through LINE OUT (fig. 2-14)

NOTE: The sync pop is not send out the line out connector but the Pre-out.

PRE OUT
The 1/4 inch PRE OUT connector on the rear panel (fig. 2-12) will send out the

SYNC POP and CLICK 1/CLICK 2 with fixed "width", "tone" and volume.

MIDI NOTES/CHANNELS

The MIDI notes/ channels for CLICK 1, CLICK 2 and SYNC POP can be changed in
SETUP.

MIDI VELOCITY
CLICK 1 and CLICK 2 can be set to respond to MIDI NOTE ON velocity.

That is used to create accents on certain clicks, normally the downbeat.

See MIDI VELOCITY in SETUP.

10